### Modified version of /boot/config.txt for CutiePi

# See /boot/overlays/README for all available options

# Uncomment some or all of these to enable optional Hardware interfaces
dtparam=i2c_arm=on
#dtparam=i2s=on
#dtparam=spi=on

# Run in 64bit mode
arm_64bit=1

# Auto load correct initramfs files if found
auto_initramfs=1

# Run as fast as the firmware/board allows
arm_boost=1

# Disable compensation for displays with overscan
disable_overscan=1

# uncomment the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if there is too much border
#overscan_left=16
#overscan_right=16
#overscan_top=16
#overscan_bottom=16

# uncomment to force a console size. By default it will be display's size minus
# overscan.
#framebuffer_width=1280
#framebuffer_height=720

# uncomment if hdmi display is not detected and composite is being output
#hdmi_force_hotplug=1

# uncomment to force a specific HDMI mode (this will force VGA)
#hdmi_group=1
#hdmi_mode=1

# Enable sound
dtparam=audio=on
# Uncomment if no sound thru hdmi
#hdmi_drive=2

# Auto load overlays for detected cameras
camera_auto_detect=1
# Auto load overlays for detected DSI displays
display_auto_detect=1

# Enable DRM VC4 V3D driver
#dtoverlay=vc4-kms-v3d
# For pi4's and above boards uncomment next line & Comment out above line
dtoverlay=vc4-kms-v3d,cma-512
max_framebuffers=2

# Don't have the firmware create an initial video= setting in cmdline.txt
# Use the kernel default instead
#disable_fw_kms_setup=1

# Disable rainbow screen at boot
disable_splash=1

# RPi 5B/4B/400 ONLY
# For 4k content @ 60 Hz refresh rate, uncomment hdmi_enable_4kp60=1
#hdmi_enable_4kp60=1
# If video breaks with hdmi_enable_4kp60=1 uncomment
#force_turbo=1

# Uncomment this to enable infrared communication.
#dtoverlay=gpio-ir,gpio_pin=17
#dtoverlay=gpio-ir-tx,gpio_pin=18

[cm4]
# Enable host mode on the 2711 built-in XHCI USB controller
# This line should be remoed if the legacy DWC2 controller is required
otg_mode=1
avoid_warnings=2

dtoverlay=cutiepi-panel
enable_uart=1
dtoverlay=uart1
dtoverlay=i2c5,pins_10_11
dtoverlay=mpu6050-i2c5,interrupt=27

start_x=1
gpu_mem=128
dtoverlay=ov5647


[all]